Download Instructions
All of our tank bras are custom cut and molded to an
actual tank here at the factory. We achieve a 100% seal against the tank
or it doesn't go out. We achieve this fit using HEAT AND PRESSURE simultaneously.
In most cases, it is very easy to align the bra to your bike using the natural
mold lines as a guide. Occasionally, it may be difficult to detect how
high or low to install the tank bra for optimum fit. The goal is to
duplicate the position on our mold to achieve a perfect 100% seal. To aid
in installation, we have created this fitment chart. The dimensions shown
are from the top edge of the bra to the filler cap cut out. Using this
dimension you can align your bra for a perfect fit.
The directions included with each bra will detail how to achieve
that 100% perfect seal using the natural heat from the sun. Once the bra
is installed and sealed, you will have a perfect fit forever without ever having
to heat it again. The first fit usually takes about 5-10 minutes
max. Although we use heat guns here at the factory to speed the process,
we don't recommend this procedure for the consumer because of the explosive
nature of the gas fumes in the tank (our tanks have never had gas in them and
are void of fumes).
Please print this chart for your initial fitment.
(click to enlarge)
HONDA
